Knowledge Base
 
TERASENS - Knowledge Base



Q10420 - ERRMSG: Error initializing DTMF detection (4122)
Author:  Frank Weber
Created: 5/25/2005
Last edited: 5/25/2005
Version: 1.0
Times viewed: 4130
Rated 4 out of 10 ( 1 votes)

Error Message

Under certain conditions the following error message may occur in the event log:

4122 - Error initializing DTMF detection. Please ensure you device supports DTMF detection and you have the latest drivers installed.

Possible Reasons

There are several possible reasons for this error to occur:

Device does not support DTMF detection

This is the most common reason for this error message. Please check the documentation of your device if it supports DTMF detection. Please also make sure that you are using the latest drivers for your device.

If you are using a CAPI based ISDN board: You can check if your device supports DTMF detection by selecting the device (ISDN Interface x...) in the device list and click on Configure. Select the interface in the tree and click Properties. Then navigate to the features tab and check the Tone Monitoring list. If there is only a Software entry but not a Hardware entry, your CAPI driver does not support DTMF detection.

Note: Software detection does not work in the current versions of TERAVoice. 

Bug in the TERAVoice Free Version with CAPI based ISDN boards

Please read the appropriate article Q10422 in the Related Articles section.

Applies To
  • TERAVoice Server 2004
Related Articles

DTMF Detection does not work with CAPI based ISDN boards and the Free Version
DTMF detection problem with CAPI based ISDN boards is fixed

Send Feedback on this Article
What do you think about this article?

1 2 3 4 5 6 7 8 9 10

poor

excellent

Do you have any additional comments? (optional)

Approved Comments

There are currently no comments for this article

 
 Write Us|  Add to favorites
 
 
 ©2009 TERASENS GmbH. All rights reserved. Copyright Notice